StopTech Street Performance brake pads are manufactured using the same positive molding process utilized by Original Equipment suppliers. Positive molding uses extreme pressure to compress the friction material and bond it to the backing plate. This process assures consistent friction material density throughout the pad, resulting in even wear and performance characteristics throughout the life of the brake pad.

StopTech Street Performance brake friction features either precision cut or shaved backing plates and mechanically attached shims; these small details ensure proper fitment in the caliper and virtually eliminate noise associated with pad vibration. In addition to these  features StopTech Street Performance are scorched; this additional process forces any impurities out of the friction material and pre-burnishes the pads to greatly accelerate the break-in process.

Scorching
All StopTech Street Performance brake pads are scorched to accelerate the break-in process. This OEM process enhances key friction performance levels. Scorching raises initial cold effectiveness, stabilizes friction levels right out of the box, provides consistent performance across the entire operating range.

During the scorching phase; each brake pad surface is super-heated to simulate the initial break-in process performed by installation technicians. This additional step removes any uncured bonding agents eliminating the need for initial break-in and reducing noise caused by pad glazing. Scorching thermally conditions the pad material which yields a more consistent and higher friction level right out of the box.
Scorching benefits the vehicle owner by promoting a more complete bed-in of new pads, increasing the effective stopping power from the first stop.